Or tips
I have the Marianne Design Creatables "Designer Doily" I just wanted to know is there any easy way of getting all the leftover bits of paper out.This must be the worst die for leaving leftover bits in. HELP!!!!!!
Hi Doreen, I don't have that die but with the Marianne dies I do have, i find that if i give it a good tap all over with an antistatic bag before i cut, then the paper just falls out if I give it a good tap. Of course i don't always remember lol Claire xx
Oh, I have that die but not used it so far - I'll need to look out my anti static bag and my pokey too methinks. It's a beautiful die though so worth the effort. Hugs xx
I have trouble with the Shapeability pendant, Fleur de lis. I just can't get the b***er out. Card, paper, can't do a thing with this one. And there are so many little bits to it too. I'll have to try some of these tips cos I don't use this lovely die as it is such a headache. I hope you have some luck and get it sorted, Doreen x
Anyone really struggling can use a little bit of spray adhesive on the die, run a thin sheet of 'packing foam' through it and then use it as normal, the packing foam stays in the die and the paper just pops out, hope this helps XXX
11 comments:
Hi Doreen have you checked out Ikkis blog?? this lady has loads of tips for dies etc.. HERE
Christine xx
Hi Doreen, I don't have that die but with the Marianne dies I do have, i find that if i give it a good tap all over with an antistatic bag before i cut, then the paper just falls out if I give it a good tap. Of course i don't always remember lol
Claire xx
Hi Doreen
after i have finished with the die i just get a pin or something with a sharp point and poke them out they come out easy that way.
Babs x
Oh, I have that die but not used it so far - I'll need to look out my anti static bag and my pokey too methinks. It's a beautiful die though so worth the effort. Hugs xx
i Use a bit of talc firsty then i use a hat pin and just pop it under one end :)
hi doreen you can try to use it one time and leave the paper in it.. and the second time the paper will come out better i hope ;-)
Ooh thanks for all your tips,I shall be trying them out.xxx
Thanks for the tips ladies, I have a MD snowflake die I haven;t really used because I can't get the paper/card out of it once cut ;-)
Hi Doreen, put it in water with a bit of fairy, they just float out.
I have trouble with the Shapeability pendant, Fleur de lis.
I just can't get the b***er out. Card, paper, can't do a thing with this one. And there are so many little bits to it too.
I'll have to try some of these tips cos I don't use this lovely die as it is such a headache.
I hope you have some luck and get it sorted, Doreen
x
Anyone really struggling can use a little bit of spray adhesive on the die, run a thin sheet of 'packing foam' through it and then use it as normal, the packing foam stays in the die and the paper just pops out, hope this helps XXX
Post a Comment